| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Z limit switch not right http://www-.luthiersforum.com/forum/viewtopic.php?f=10106&t=41517 |
Page 1 of 1 |
| Author: | Bobc [ Sat Sep 28, 2013 10:16 am ] |
| Post subject: | Z limit switch not right |
My z limit switch settings are not right. If soft limits are on Z axis will only travel about .300 and stops about 1/" away from the Z limit swich. If I turn soft limits off Z axis will travel up & down just fime. So how do I reset that abosulte Z limit? Driving me crazy. |
|
| Author: | Chris Pile [ Sat Sep 28, 2013 10:58 am ] |
| Post subject: | Re: Z limit switch not right |
What machine do you have? |
|
| Author: | Andy Birko [ Sat Sep 28, 2013 1:41 pm ] |
| Post subject: | Re: Z limit switch not right |
Are you using Mach 3? If so, I can help. |
|
| Author: | Bobc [ Sat Sep 28, 2013 5:11 pm ] |
| Post subject: | Re: Z limit switch not right |
Cobra 404 with ATC using WinCNC. Issue resolved. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|